Clear Flo Plus Manuel du propriétaire Page 5

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 4
5
4. STORAGE TANK INSTALLATION
The storage tank may be placed in either the vertical or horizontal position without affecting system performance. Put
four to five wraps of Teflon tape around the metal stem at the top of the tank. Hand tighten the plastic shut off ball
valve found in the installation packet down on to the tank stem. Do not over tighten.
Note: Tank air pressure can be measured at the air stem on the opposite side of tank. It may be covered with a blue
cap. Tank air pressure should be between 8-11 PSI when empty.
5. TUBING CONNECTIONS (systems may not have color-coded tubing or different color codes)
Feed (Red) – connects main water supply feed to elbow fitting on right side of unit
Drain (Black) – connects drain saddle to bottom fitting on membrane housing
(inline flow restrictor necessary on this line)
Tank (White) – connects tank ball valve to tee fitting on inline filter
Faucet (Blue) – connects faucet to elbow fitting on left side of inline filter
6. UNIT STARTUP
The RO unit may be mounted on the wall though not necessary. To mount, use the bracket holes on the RO unit
as a guide, and with the screws provided in the install pack, mount the system in the desired location. With all
tubing connections complete, turn on the cold water supply to the RO unit and open all ball valves. Ball valves are
open when the handle runs parallel to the tubing. Immediately check the entire system for leaks. If you notice any
leaks turn off water supply and tighten where necessary. With the RO system on, lift the drinking faucet handle
until water begins to drip out. Next, close the faucet to allow the tank to fill. This may take 3-4 hours depending
on size of system. Once the tank is full it is recommended to flush completely. Open and leave open the drinking
water faucet until the water coming out again slows to a dribble. This signifies the tank is empty. The drinking
faucet can then be closed to allow the tank to fill again. At this point the water is ready for consumption.
Vue de la page 4
1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire