4
2. FEED WATER ASSEMBLY
Turn off cold water supply to the sink using the supply valve
located under the sink. Different systems will come with different
adapters types and styles. Shown below are a few of the most
common options. Only install to cold water supplies and do not
over tighten fittings.
Note: Some shut off valves have an extra port or a separate
valve plumbed for an icemaker or filter system. In either of these
cases you will not need the feedwater adapter, just hook the
feed line directly to this access point.
Scenario 1: Plastic Feed Water
Make sure the black washer is seated in the feedwater adapter.
Tighten feedwater adapter to the valve with an adjustable
wrench. Tighten until snug but do not over tighten. Connect the
tubing feed line (usually red in color) by plugging the tubing
end into the feed water connector collet, cut the tubing line
anywhere along it, and install the inline ball valve, again by
pushing the tubing ends securely into the collets.
Installation of Feed Water Supply
1. Shut off water supply at brass/chrome supply valve.
2. Disconnect riser from brass/chrom supply valve.
3. Ensure that the sealing gasket is fully seated into the Angle Stop Valve female thread.
4. Install Angle Stop Valve on supply valve.
5. Connect the riser to the Angle Stop Adapter Valve.
6. Fully insert tubing into the Sppedfit side of the valve.
7. Open valves and check for leaks.
3. DRAIN INSTALLATION
Peel the protective film off of the foam gasket and apply to
inside of drain saddle, using care to align foam gasket hole with
drain port. Position the drain saddle on the vertical or horizontal
drainpipe from your sink. Position as far away from the garbage
disposal as possible and after the P-trap. Drill 1/4” (6mm) hole
into the drainpipe where the drain saddle will be mounted. Do
not drill all the way through—stop after piercing the first wall
of the pipe. Mount the drain saddle and align the hole using a
small drill bit or other small straight object. Gently tighten the two
screws evenly on both sides of the clamp until the clamp is snug
on the pipe. Do not over tighten.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels